Stripping is the act of removing the protective polymer coating around optical fiber in preparation for fusion splicing. The splicing process begins by preparing both fiber ends for fusion, which requires that all protective coating is removed or stripped from the ends of each. Fiber strippers are precision tools that reliably and cleanly remove a defined length of coating (often 30–40 mm) from a fiber end so that the bare glass is exposed without scratching or nicking it. Mechanical fiber strippers for Large Diameter Fibers (LDF) for removing various coating materials from windows and fiber ends. Without question, good stripping techniques in your fiber. Laser stripping from OpTek Systems provides controllable and reproducible removal of acrylate or polyimide buffers with tight control over the position, location, and fiber-strength.
[pdf] Optical fibers can be used as sensors to measure, , and other quantities by modifying a fiber so that the quantity to be measured modulates the,,, or transit time of light in the fiber. Sensors that vary the intensity of light are the simplest, since only a simple source and detector are required. A particularly useful feature of intrinsic fiber-optic sensors is that they can, if required, provide distributed sensing over very large distances.
[pdf] To improve the safety and efficiency performance of partial discharge detection in a high-voltage direct current (HVDC) cable system, an optical fiber ultrasonic detection system for partial discharge is carried o.
[pdf] Optical time-domain reflectometer is a measuring instrument used for fiber optic testing and analysis. It can detect and locate events in the optical fibers, such as connection points, fracture points, bending points, etc., by analyzing the measurement curve. These fibers are most commonly made of glass and are very thin, typically less than a tenth of the width of a human hair. No setup or interpretation needed – light and sound indicate presence of an optical signal. This technology is particularly useful when the precise installation path of the cable is unknown or differs from the original plans.
[pdf] Fiber Breakage: Multimode fiber optic cables can be prone to fiber breakage, which can result in signal loss. This is made possible by its relatively large core diameter, typically 50 or 62. 5 microns, compared to the ~9-micron core in single-mode fiber. Although they can do the same job in some instances, the different construction methods make each of them better suited to certain tasks and budgets. Multi-mode fiber has a fairly large core diameter that enables multiple light modes to be. Multimode fibers have a larger core and/or a larger index difference between core and cladding, so that they support multiple modes (possibly hundreds or more) with different intensity distributions (Figure 3). For example, an MPO or MTP end on one side can be split into multiple LC ports on the other.
[pdf] 
